All Collections
How to install the Eagle Plugin?
How to install the Eagle Plugin?

Guide to install the SnapMagic plugin for Eagle

Ana Trujillo avatar
Written by Ana Trujillo
Updated over a week ago

How to Install the SnapMagic Plugin for Eagle

  1. Download Eagle (if necessary)

  2. Upon launching Eagle, you’ll see the Control Panel. Go to File > Open > Scripts > and select eagle.scr.

  3. Copy and paste the following line to the MENU area of both the BRD and SCH sections: 

    '[bin/snapeda.png] SnapEDA : Run snapeda.ulp;'\

  4. Download the SnapEDA Eagle Plugin ( Unzip the file and move both snapeda.ulp and into Documents > eagle > ulps.

  5. Copy snapeda.png from the SnapEDA Eagle-Plugin folder and paste it in the bin folder located inside your Eagle directory (C:\EAGLE 9.x.x\bin).

  6. The SnapMagic plugin is now installed. When you start a new Schematic or Board, you should be able to see the SnapEDA icon in the top menu bar.

Note: If you are using older versions of Eagle,move both snapeda.ulp and into the ulp folder in the Eagle application directory.

Did this answer your question?